Fagor CNC 8065 - Page 542

·542·
Installation manual
CNC 8060
CNC 8065
10.
CNC VARIABLES.
(REF: 1402)
Variables related to general machine parameters.
SERCOS BUS CONFIGURATION
(V.)MPG.SERBRATE
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Sercos transmission speed
Values of the variable.
This variable returns one of the following values.
(V.)MPG.SERPOWSE
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Sercos optical power.
MECHATROLINK BUS CONFIGURATION.
(V.)MPG.MLINK
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Mechatrolink mode.
Values of the variable.
This variable returns one of the following values.
(V.)MPG.DATASIZE
Telegram size in Mlink-II mode.
Variable that can only be read from the program, PLC and interface.
The variable returns the value of block preparation.
Telegram size in Mlink-II mode.
V.MPG.SERBRATE
Value. Meaning.
0 4 Mbps.
1 2 Mbps.
2 16 Mbps.
3 8 Mbps.
V.MPG.SERPOWSE
V.MPG.MLINK
Value. Meaning.
0No.
1Mlink-I
2Mlink-II
V.MPG.DATASIZE