Fargo DTC400 User Manual

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400 Card Printer/Encoder User Guide (Rev. 2.2)
vii
Reviewing the Custom VeriMark Card (Custom Graphic in a 2D foil) _______________________ 6-70
Reviewing the Custom HoloMark Card (Custom Graphic in a 2D foil) ______________________ 6-71
Using the K Panel Resin tab __________________________________________________________ 6-72
Enabling the Frontside and Backside options___________________________________________ 6-73
Enabling the Frontside option (K Panel Resin) _________________________________________ 6-74
Enabling the Backside option (K Panel Resin)__________________________________________ 6-75
Selecting from the Print All Black With K Panel options (Front and Back options) _____________ 6-76
Selecting the Full Card option (Front and Back options) __________________________________ 6-77
Selecting the Defined Area(s) option (Front and Back options)_____________________________ 6-78
Selecting the Undefined Area(s) option (Front and Back options)___________________________ 6-79
Selecting the Defined Area(s) function (Front and Back options) ___________________________ 6-80
Selecting the Print YMC under K and Print K Only options _______________________________ 6-87
Using the Printer Supplies tab (DTC400) ________________________________________________ 6-88
Reviewing the Ribbon Information __________________________________________________ 6-89
Reviewing the Ribbon Level Indicator________________________________________________ 6-90
Using the Printer Calibration Utility (DTC400) ___________________________________________ 6-91
Using the Image Darkness Option ___________________________________________________ 6-92
Using the Print Top of Form Option__________________________________________________ 6-93
Using the Print End of Form Option__________________________________________________ 6-94
Using the Print Left of Form Option _________________________________________________ 6-95
Using the Magnetic Encoder Voltage Offset Option _____________________________________ 6-96
Adjusting the Hi-Co Voltage Offset__________________________________________________ 6-97
Adjusting the Lo-Co Voltage Offset__________________________________________________ 6-98
Using the Mag Top of Form Option__________________________________________________ 6-99
Using the Ribbon Tension Option __________________________________________________ 6-101
Using the LCD Contrast Option ____________________________________________________ 6-101
Using the Flipper Home Offset Option_______________________________________________ 6-102
Using the Flipper Center Offset Option ______________________________________________ 6-102
Using the Flipper Smart Angle Offset Option _________________________________________ 6-103
Section 7: Cleaning________________________________________________________7-1
Safety Messages (review carefully)______________________________________________________ 7-1
Using the Required Supplies ________________________________________________________ 7-2
Cleaning Procedures _________________________________________________________________ 7-3
Cleaning the Printhead _____________________________________________________________ 7-3
Cleaning the Card Feed and Cleaning Rollers ___________________________________________ 7-4
Cleaning the Printer's Interior________________________________________________________ 7-5
Section 8: Packing the Card Printer___________________________________________8-1
Section 9: Board Level Diagnostics ___________________________________________9-1
Safety Messages (review carefully)______________________________________________________ 9-1
Sensor and Motor ___________________________________________________________________ 9-2
Reviewing the Sensor Location and Voltages ___________________________________________ 9-2
Reviewing the Motor Voltages (when active) ___________________________________________ 9-2
Section 10: Menu Option Tree ______________________________________________10-1
Accessing the Menu Option Structure Tree ____________________________________________ 10-1
Selecting from the Menu Option Structure Tree (displayed, below) _________________________ 10-1
Section 11: Firmware Upgrades_____________________________________________11-1
Introduction_______________________________________________________________________ 11-1
Requirements______________________________________________________________________ 11-2
Safety Messages (review carefully)_____________________________________________________ 11-2
Downloading Firmware ___________________________________________________________ 11-3
Placing the Printer in the Firmware Upgrade Mode _______________________________________ 11-17
Sending the Firmware File __________________________________________________________ 11-19

Fargo DTC400 Specifications

General

Brand	Fargo
Model	DTC400
Category	Printer
Language	English