FEC Handheld Nutrunner HFC3000 - Page 191

Chapter 9 Fieldbus I/O Interfaces
PAGE 9-11
● EDS File
An EDS file is an information file related to the communication specifications of EtherNet/IP-compatible device
and a separate, individual file exists for each device. The EDS file is necessary for using the PLC EtherNet/IP
configuration software to connect the MFC-EN and the PLC.
The EDS file is included in the installation CD and/or downloadable from the FEC website. Please refer to the
PLC instruction manual for the EtherNet/IP configuration software concerning the appropriate method for using
the EDS file.
● Module Pin Configuration
No.
Signal
Description
1
TD+
Send data +
2
TD-
Send data -
3
RD+
Receive data +
4
-
Not used
5
-
Not used
6
RD-
Receive data -
7
-
Not used
8
-
Not used
* The cable is not included with the equipment. Please provide a LAN cable of Category 5e or higher.
・Be sure to connect the cable with all power turned OFF.