Chapter 4 Installation and Wiring
PAGE 4-16
CF WARNING PIN No.: TB2-2 OUT-2
ON when the remaining capacity of the CF (compact flash) card is less than 200MB
(firmware version 1.310 or later)
BATCH SEQUENCE END PIN No.: TB2-3 OUT-3
ON when using the BATCH SEQUENCE function (fastening parameter D-No. 580 is set to “1”) and
the sequence has reached the final stage (operation is completed)
(firmware version 1.310 or later)
WORK OUTPUT 0 ~ 5: WORK SELECTION INPUT CONFIRMATION
Output confirmation of the WORK SELECT 0~5 input selections. These bits are active according to
what parameter is set from the Work Select inputs.
Used to confirm proper selection before starting a fastening cycle.
To Next Page
Loading...