STARTING AND DRIVING
196
When leaving the curve, the device
resets the previously set speed.
232 F1A0997
WARNING In case of narrow curves,
the performance of the device could be
limited. In this case, it is advisable to
deactivate the device. In this case, it is
advisable to deactivate the device.
Using the device on gradient
When driving on roads with variable
gradient, the device may not detect
the presence of a vehicle on the lane.
Device performance could be limited
according to speed, load, traffic
conditions and gradient steepness.
Lane change
The device may not detect the
presence of a vehicle until it is fully in
your lane fig. 233.
In this case, sufficient distance from the
vehicle which is changing lane may not
be guaranteed: it is advisable to pay
the utmost attention at all times and
be always ready to press the brakes if
needed.
233 F1A0996
Small vehicles
Some narrow vehicles (e.g. bicycles
and motorcycles fig. 234) travelling
near the outer edges of the lane or
which enter the lane from kerbside are
not detected until they are fully in the
lane.
Sufficient distance from the vehicles
ahead may not be guaranteed in these
cases.
234 F1A0995
Stationary objects and vehicles
The device cannot detect the presence
of stationary vehicles or objects. For
example, the device will not operate if
the vehicle ahead leaves the lane and a
vehicle ahead of that one is standing on
the lane. Pay the utmost attention at all
times and be always ready to press the
brakes if needed.
Objects and vehicles moving in
opposite or crosswise direction
The device cannot detect the presence
of objects or vehicles travelling in
opposite or crosswise direction fig. 235
and consequently will not be operated.