IN CASE OF EMERGENCY
250
195)
Repair and refit the standard wheel
as soon as possible. Do not apply grease
to the bolt threads before fitting: they
could come unscrewed.
196)
Use the jack only to replace wheels
on the vehicle with which it is supplied or
on other cars of the same model. Never
use the jack for other purposes, such as
lifting other vehicle models. Never use the
jack to carry out repairs under the vehicle.
Incorrect positioning of the jack may cause
the lifted vehicle to fall. Do not use the jack
for loads higher than the one shown on its
label.
197)
Never tamper with the inflation valve.
Never introduce tools of any kind between
rim and tyre. Check tyre and spare wheel
pressure regularly, referring to the values
shown in the "Technical specifications"
section.
198)
No tools other than the crank
provided should be used with the spare
wheel lifting device; it should be operated
by hand only.
199)
On versions equipped with
self-levelling air suspension, never
introduce the head or hands in the wheel
arch. The vehicle could raise or lower
automatically depending on possible load
or temperature changes.
200)
The device should only be operated
by hand, without using any type of
tool other than the crank provided like
pneumatic or electrical screwdrivers.
201)
The moving components of the jack
(screws and joints) can also cause injuries:
avoid touching them. If you come into
contact with lubricating grease, clean
yourself thoroughly.
202)
At the end of the operation of
raising/locking the spare wheel, after
having checked the correct positioning
of the wheel under the platform (yellow
notch inside the window on the device),
the spanner must be extracted, taking care
not to turn it in the wrong direction (as in
fig. 305) to facilitate the extraction of the
spanner itself, to prevent the attachment
device from being released and the wheel
assembly not being securely retained.
203)
Each time the spare wheel is moved,
check that it is correctly positioned in its
housing under the platform. If it is not
correctly positioned, this could adversely
affect safety.
204)
The spare wheel lifting device is
equipped with a clutch safety system for
its own protection; this could activated
if an excessive load is applied on the
manoeuvring screw.
FIX&GO AUTOMATIC
QUICK TYRE REPAIR
KIT
(for versions/markets, where provided)
205) 206) 207) 79) 80) 4)
The Fix&Go tyre repair kit is located
at the front of the vehicle passenger
compartment and includes fig. 310:
310 F1A0743
a spray can (A) of liquid sealant,
complete with clear filler hose (E); black
pressure top-up hose (C); sticker (D)
marked max. 80 km/h to be affixed in
a position in clear view of the driver (on
the dashboard) after the tyre has been
repaired;
a compressor (F) provided with an
electrical connector (H);
a pair of protective gloves located in
the spray can compartment.
To Next Page
Loading...
