41
To deactivate the automatic function
rotate the light switch ring to position
.
Flashing the headlights
To flash, the unstable position is
used (activate by pulling the lever (A)
fig. 84 towards you). With high beam
headlights on, the warning light on
the instrument panel will come on at
the same time.
84 F1A0614
DIRECTION INDICATORS
Take the left stalk fig. 82 to the (stable)
position:
upwards
: activates the right direction
indicator;
downwards
: activates the left
direction indicator.
The or warning light respectively
will flash on the instrument panel.
The direction indicators switch off
automatically when the steering wheel
is straightened or when the daytime
running lights (DRL) are switched
/parking lights are activated.
"Lane Change" function
To indicate a change of lane with the
car moving, move the left lever to the
non-stable position for less than half a
second.
The direction indicator on the side
selected will be activated for 5 flashes
and then go out automatically.
COURTESY LIGHTS
This function, with the ignition device in
STOP, allows activating the side lights
and the number plate lights for 30, 60
or 90 seconds, whenever the vehicle
is unlocked with the key with remote
control.
The function can be enabled and the
activation time can be set using the
display Menu or the Uconnect™
system.
The function is automatically disabled
once the activation time elapses, or
when the vehicle doors are locked
again, or by turning the ignition device
to a position other than STOP.
LIGHT BEAM DIRECTION
The correct alignment of the headlights
is essential for the comfort and safety
of the driver and other road users. To
ensure the best visibility when travelling
with the headlights on, the headlight
alignment must be correct. Contact a
Fiat Dealership to have the headlights
checked and adjusted.
HEADLIGHT ALIGNMENT
CORRECTOR
This device works with the ignition
key in the MAR position and the
dipped headlights on. The vehicle tilts
backwards when it is laden, raising the
beam. The beams must therefore be
realigned in this case.
Headlight alignment adjustment
Press the buttons (A) or (B) on
the control panel fig. 85 to adjust.
The instrument panel display shows the
position in relation to the adjustment
set.
WARNING Check the alignment of the
light beams each time the weight of the
load transported changes.
85 F1A0690
To Next Page
Loading...
