23
27 F1A0618
LOCKING/UNLOCKING
THE LOAD
COMPARTMENT
Lock activation is indicated by the LED
in the button (D) fig. 28.
The LED comes on in the following
cases:
after each door lock command
generated by the button (D) fig. 28 or
by button in the dashboard;
when the lock buttons on the key are
pressed;
when the Passive Entry/Keyless Entry
system is used;
when the instrument panel is
activated;
upon opening of one of the front
doors;
when the door is locked at 20 km/h
(if activated using the menu).
The lock is turned off when one of the
load compartment doors is opened
or on a door release request (load
compartment or centralised) or an
unlocking request from the remote
control/door latch or by using the
Passive Entry/Keyless Entry.
28 F1A0761
DEAD LOCK DEVICE
(for versions/markets, where provided)
It is a safety device that disables
operation of the interior handles.
Press the lock/unlock button (A) fig. 24
to prevent opening the doors from
inside the passenger compartment in
the event of an attempted break-in (e.g.
when a window is broken).
The dead lock device therefore offers
the best possible protection against
break in attempts. We recommend
engaging it whenever the vehicle is
parked and left unattended.
11)
Device activation
The dead lock device is automatically
activated on every door with two short
presses on the button on the key
with remote control fig. 23.
For vehicles equipped with the Passive
Entry/Keyless Entry system, Dead Lock
is activated every time the vehicle is
locked using the button on the outside
handle.
The direction indicators flash 3 times
and the LED on the button (A) fig. 24
among the dashboard controls flashes
to indicate that the device has been
turned on.
If one or more of the doors is not
perfectly shut, the dead lock device
will not be activated, thus preventing a
person getting into the vehicle through
the open door and, on shutting, it,
remaining stuck inside the passenger
compartment.
The device will not engage with the
key in the MAR position. The device is
only activated with the key in the STOP
position.
Device deactivation
The system is disabled automatically on
every door in the following cases:
if the mechanical key is turned to the
opening position in the driver's door;
by unlocking the doors using the
remote control;
by turning the ignition key to the
MAR position.
To Next Page
Loading...
Need help?
General
