Fiat Ducato 2021 - Cleaning; Error Message; Reset; Scrapping

KNOWING YOUR VEHICLE
64
error messages are also marked
with a "!". Error messages must be
acknowledged as soon as they appear
by pressing the control button. The
main menu is only displayed again after
confirmation.
The "Settings" menu item has been
selected.
Turn the control button to select the
"Error Message" menu item.
Then press the control button
to confirm the selection. The error
message (or messages) appears on the
display. "OK" appears on the display if
there is no error message. In case of
repeated error messages, all messages
can be called up by turning the control
button.
Press the control button to go back
to the menu item.
Reset
Reset restores all the basic
configuration settings (basic settings by
the technician) except for the day of the
week and the time.
The "Settings" menu item has been
selected.
Turn the control button to select the
"Reset" menu item.
Then press the control button to
confirm the selection. "OK" will appear
on the display
Then press the control button to
confirm the selection. A reboot is
performed.
Your personal settings are cleared. This
process cannot be retroactive.
CLEANING
Use only a soft, lint-free cloth to clean
the control panel. No moisture may
enter the housing. Do not use glass
cleaners, household cleaners, sprays,
solvents, alcohol-based cleaners or
abrasive products for cleaning.
ERROR MESSAGE
Heater error messages are displayed
as "F" or "H" and must be taken from
the respective heater description. Error
messages on the control panel are
displayed with a "T".
An error message appears on the
display.
Press the control button to confirm
the error message.
The error message is stored in
the error memory.
If no confirmation is received,
the error message is displayed
again (e.g. when restarting or
exiting standby mode).
Error codes
If an error message appears on the
display, contact Customer Service.
WARNING: Maintenance and repair
work on heaters must only be carried
out by trained qualified personnel.
Excerpt of control panel error
messages
T84 - Low voltage (power supply is
low). Charge the battery or check the
electrical system of the vehicle.
Te4 - Fault status LED. Contact
Support/Customer Service.
Teb - Time error. In case of a power
failure longer than 8 minutes: re-enter
date/time. If the error occurs without
voltage interruption: contact the
Service/Customer Service department.
T12 - Faulty W-Bus communication.
Wrong heater selected.
Follow the procedure in the
installation instructions. Contact
Support/Customer Service (if
necessary).
SCRAPPING
The control panel must not be
disposed of with household waste.
Comply with regional regulations
regarding the disposal of electronic
products.
ASSISTANCE AND CUSTOMER
SERVICE
Do you have technical questions or a
problem with your device? Do you have