255
Reset procedure In case of a minor
collision, simply turn the key to STOP
and then restart. In the event of a major
collision, you must call for assistance,
as restarting the vehicle is not possible.
AUTOMATIC
TRANSMISSION
GEAR LEVER
RELEASE
In the event of a failure, to move the
gear lever from P (Park), proceed as
follows:
switch off the engine;
engage the parking brake;
working carefully in the point
indicated by the arrow, fig. 316,
remove the gaiter lifting it upwards;
316 F1A0707
depress the brake pedal and keep it
fully depressed;
insert the supplied screwdriver
perpendicular into the release hole
in the rear right corner of the gear
selector unit (fig. 317) and press the
release lever and the button on the
knob at the same time;
317 F1A0708
move the gear lever to N (Neutral);
refit the gear lever gaiter correctly;
start the engine.
IGNITION KEY
EMERGENCY REMOVAL
(versions with automatic transmission)
81)
The ignition key (for versions with
key without remote control) can be
removed only if the gear lever is in
position P (Park).
If the vehicle battery is flat and the
ignition key is engaged, the latter is
locked in position.
Follow these steps to extract the key
fob manually:
stop the vehicle in safe conditions,
engage a gear and the parking brake;
using the key (A) fig. 318provided
(located in the container with the
handbook), undo the fixing screws (B)
fig. 319 of the lower trim;
318 F1A0477
319 F1A0767
remove the lower steering column
trim (C) fig. 319 releasing it from its
housing;
pull tab (D) fig. 320 downwards
using one hand and with the other one
remove the key, sliding it outwards;
To Next Page
Loading...
