KNOWING YOUR VEHICLE
40
wide wheel rotation angles or at the
switching on the direction indicator, a
light will turn on (built in the front fog
light) referring to the turning side which
will extend the night visibility angle.
To turn on the front/rear fog lights, use
button (A) fig. 83 as follows:
first press: front fog lights and side
lights switch on if the dipped beam
headlights are off. Only front fog
lights switch on if the dipped beam
headlights are on. The warning light
switches on in the instrument panel;
second press: turns on the rear fog
lights, the warning light on the
instrument panel will turn on;
third press: front/rear fog lights
and side lights switch off if dipped
beam headlights are off. Only front fog
lights switch off if the dipped beam
headlights are on;
fourth press: rear fog lights switch off
if dipped beam headlights are on.
83 F1A0689
REAR FOG LIGHT
The rear fog light button is located on
the left control panel (button (A) fig. 83).
With rear fog lights on, the warning light
on the instrument panel will come
on at the same time.
PARKING LIGHTS
These lights can be turned on only
with the ignition device at STOP or key
extracted by turning the ring on the
left stalk first to position and then to
positions .
The warning light switches on in the
instrument panel.
Repeat the same operation to switch
them off.
With the parking lights on, a buzzer
will sound with the parking lights on.
The buzzer switches off as soon as the
driver's door is closed.
"FOLLOW ME HOME"
DEVICE
Activation
Bring the ignition device to STOP.
Within 2 minutes pull the left stalk
in main beam headlights flashing
mode, each displacement of the stalk
will correspond to an increment of
30 seconds of delay on headlights
switching off up to a maximum of 210
seconds (equal to 7 flashes).
Deactivation
Keep the left stalk in main beam
headlight flashing mode for a few
seconds.
MAIN BEAM HEADLIGHTS
With ring in position , push the stalk
forward toward the dashboard (stable
position). The warning light switches
on in the instrument panel. The lights
are switched off by pulling the stalk
towards the steering wheel.
AHB (Automatic High Beam)
System
(where provided)
The system controls the automatic high
beam headlights providing increased
forward lighting at night by automating
high beam control using of a digital
camera mounted on the interior rear-
view mirror.
NOTES
The Auto Dim High Beams control
can be turned on or off using the
Uconnect™ system. Refer to
the “Settings” paragraph in the
“Multimedia” section for further
information.
Broken, muddy or obstructed
headlights and side lights of vehicles
in the field of view of the camera will
cause headlights to remain on longer
(closer to the vehicle).
To Next Page
Loading...
