Fiat Ducato 2021 - Combi Versions; Panorama Versions; Seat Base Plastic Covers; Stacked Position

31
54 F1A0032
SEAT BASE PLASTIC
COVERS
(for versions/markets, where provided)
The front trim (A) fig. 55 can be opened
by using the release handle (B) fig. 55
at the top.
This gives access to the tray under
the seat (see "Tray under the seat"
paragraph).
To make it easier to open the
front cover and gain access to the
compartment, the seat must be as far
back as possible.
To allow removal of the front cover,
it must be turned as far forward as
possible and withdrawn from the hooks
on the lower side by pulling toward the
front of the vehicle.
55 F1A0033
PANORAMA VERSIONS
Adjustment of passenger seat
reclining backrest
Turn knob (A) fig. 56.
56 F1A0034
Access to second row seats
To access the second row of seats,
operate the lever (B) fig. 56 on the right
outside seat in the first row and tilt the
backrest forward, accompanying it with
your left hand.
When the seat is restored to its normal
position, it engages with the retaining
device without the need to operate
the lever again. On the one-piece
Panorama seat in the second row both
side seats are fixed.
Folding middle seat backrest (2
nd
-
3
rd
row)
Lift the lever (C) fig. 56 and tilt the
backrest forward.
A hard surface on the back of the
middle seat is for use as an armrest
and table with cup holders.
Operate the lever to reposition the
backrest.
To lower the backrest of the middle
seat in the second row, remove the
head restraint to make it easier to
adjust the backrest of the middle seat
in the first row.
COMBI VERSIONS
Easy Entry position
Lift the lever (A) fig. 57 and tilt the
backrest forward.
Stacked position
Proceed as follows:
– remove the head restraints from the
Easy Entry position;
– lift the lever (B) fig. 58 (located under
the lever (A) fig. 57) with your right
hand;