Fike Clean Agent System - 1.9 Container Ordering Format

SECTION 1 – EQUIPMENT
Page 20 of 25 Fike Clean Agent System w/ FM-200™ UL / ULC Ex4623
Revision Date: January, 2010 Manual P/N: 06-215 (Rev G) FM 3010715
1.9 CONTAINER ORDERING FORMAT
In addition to the basic container part number that identifies the capacity and type of container, there are a series
of options that must be defined when placing an order for a Fike Clean Agent Container.
70 – X X X
* – X X X X – X X X X – 06
A B C D E F G
A = Basic container part number (i.e. 70-155, 70-041, 70-155 etc.)
* Placing a T after the basic container number indicates the container will be supplied with the discharge valve
outlet threaded to the container. Without T indicates the container will be supplied with the discharge valve
outlet welded to the container.
EXAMPLES:
70-155 is basic container part number for a 375 lb. container fabricated to meet DOT requirements and
the container is stamped with the DOT number.
NOTES:
1) If container being ordered needs to meet Transport Canada (TC) requirements and be dual stamped with
appropriate DOT and TC numbers, this requirement must be indicated on your purchase order.
2) Containers are available in the following colors:
 White
 CO
2
Red
This option needs to be indicated on your purchase order.
B = Agent quantity in lbs. (container must be filled in 1 lb. increments)
Agent quantity in kg (container must be filled in 0.5 kg increments)
For “Field Initial Fill”, enter <0000>
C= 0 – Field Initial Fill, container is pressurized to 120 psig with dry nitrogen @ 70
o
F (8.3 bar @ 21
o
C)
1 – Factory Fill, container is pressurized to 360 psig with dry nitrogen @ 70
o
F (24.8 bar @ 21
o
C)
D = 0 – Pressure Gauge and Liquid Level Indicator required
1 – Pressure Gauge “Only”
2 – Pressure Gauge, Liquid Level Indicator and Low Pressure Switch
3 – Pressure Gauge and Low Pressure Switch
NOTE: LLi is standard on containers with threaded valves (215, 375, 650 & 1000 lb.) LLi is not available on
the 100 lb. container with threaded valve.
E = 3 – Agent Release Module required for control panel
0 – No ARM, When ordering a replacement container
NOTE: An Agent Release Module is required for each container. Always indicate <3> unless ordering a
replacement cylinder.
F = 0 – No Mounting Bracket required
1 – Standard Mounting Bracket required
G = 5 – HFC-227ea
English Units Example: Part Number 70-077-190-1031-05 indicates the following: the customer wants a 70-
077, Inverted 215 lb. Container Assembly, factory-filled with 190 lbs. of HFC-227ea, pressurized to 360 psig
@
70
o
F, with a pressure gauge and liquid level indicator installed, an agent release module, and a standard
mounting bracket.
Metric Units Example: Part Number 70-077-086.5-1031-05 indicates the following: the customer wants a 70-
077, Inverted 90 L Container Assembly, factory-filled with 86.5 kg of HFC-227ea, pressurized to 24.8 bar
@ 21
o
C,
with a pressure gauge and liquid level indicator installed, an agent release module, and a standard mounting
bracket.