FLENDER K.SH - Page 4

Table of contents
4 Edition 06/2022 A5850-02en
3.9 Shrink disk ...............................................................................................................................36
3.10 Heating.....................................................................................................................................37
3.11 Oil level indicator......................................................................................................................38
3.12 Oil temperature monitoring ......................................................................................................38
3.13 Bearing monitoring...................................................................................................................39
3.13.1 Bearing monitoring by shock-pulse transducer........................................................................39
3.13.2 Bearing monitoring by acceleration sensor..............................................................................40
3.14 Gear changing .........................................................................................................................42
4 Application planning ................................................................................................................................43
4.1 Scope of delivery .....................................................................................................................43
4.2 Transport..................................................................................................................................43
4.3 Attachment points ....................................................................................................................45
4.4 Special aspects of gear unit lubrication and preservation........................................................47
4.4.1 Oil filling point and oil drain ......................................................................................................47
5 Assembly...................................................................................................................................................49
5.1 General assembly instructions.................................................................................................49
5.2 Unpacking the gear unit ...........................................................................................................50
5.3 Gear unit assembly ..................................................................................................................51
5.3.1 Foundation ...............................................................................................................................51
5.3.2 Description of assembly work ..................................................................................................52
5.3.2.1 Alignment .................................................................................................................................53
5.3.3 Mounting the gear unit on the housing mounting foot..............................................................55
5.3.3.1 Installation on a foundation frame............................................................................................55
5.3.4 Shaft-mounted gear unit with solid shaft..................................................................................56
5.3.5 Shaft-mounted gear unit with hollow shaft and parallel keyway ..............................................57
5.3.5.1 Preparations.............................................................................................................................57
5.3.5.2 Mounting ..................................................................................................................................58
5.3.5.2.1 Mounting ..................................................................................................................................58
5.3.5.2.2 Axial locking .............................................................................................................................59
5.3.5.3 Dismantling ..............................................................................................................................60
5.3.6 Shaft-mounted gear unit with hollow shaft and shrink disk ......................................................61
5.3.6.1 Preparations.............................................................................................................................62
5.3.6.2 Mounting ..................................................................................................................................62
5.3.6.2.1 Pulling on with integrated DU bushing .....................................................................................63
5.3.6.2.2 Mounting with DU bushing as a separate component .............................................................65
5.3.6.2.3 Axial locking .............................................................................................................................65
5.3.6.3 Dismantling ..............................................................................................................................66