FLENDER K.SH - General Warnings and Symbols; Special Types of Danger and Personal Protective Equipment; Table 2-1 Symbols and Markings; Table 2-2 General Warnings

Safety instructions
2.4 General warnings and symbols
A5850-02en Edition 06/2022 17
Points labelled on the gear unit Symbol Coloured markings
These symbols indicate that the oil dip-
stick must be firmly screwed in.
Table2-1: Symbols and markings
2.4 General warnings and symbols2.4 General warnings and symbols
The following table contains general warnings and their associated symbols.
ISO ANSI Warning
Warning – hazardous electrical voltage
Warning – explosive substances
--- Warning – entanglement hazard
--- Warning – hot surfaces
--- Warning – corrosive substances
--- Warning – suspended load
--- Warning – hand injuries
Table2-2: General warnings
2.5 Special types of danger and personal protective equipment2.5 Special types of danger and personal protective equipment
Requirements
Fulfil the following requirements before commencing work on the gear unit:
• Ensure that the oil pressure lines are depressurised.
• Only perform work on the gear unit when it is not in operation.
• Disconnect electrical systems from the power supply.