FLENDER K.SH - Page 9

A5850-02en Edition 06/2022 9
List of figures
Figure3-1 Output shaft versions .................................................................................................................24
Figure3-2 Gear unit equipment on gear units of type K..H .........................................................................25
Figure3-3 Gear unit equipment on gear units of type K..M.........................................................................26
Figure3-4 Rotary shaft sealing ring.............................................................................................................27
Figure3-5 Labyrinth seal.............................................................................................................................28
Figure3-6 Taconite seal..............................................................................................................................28
Figure3-7 Design variants of Taconite seals ..............................................................................................29
Figure3-8 Tacolab seal...............................................................................................................................31
Figure3-9 Fan .............................................................................................................................................32
Figure3-10 Cooling coil on type K..H and K..M gear units............................................................................34
Figure3-11 Heating.......................................................................................................................................37
Figure3-12 Oil temperature monitor mounted on the gear unit ....................................................................39
Figure3-13 Bearing monitoring system with shock-pulse transducer on type K..H and K..M gear
units:...........................................................................................................................................40
Figure3-14 Fully assembled acceleration sensor (A), and threaded connector (B) for variants 1 to 4.........41
Figure3-15 Fully assembled acceleration sensor (C), and the threaded connector (D) for variants 5A
and 5B........................................................................................................................................41
Figure4-1 Transport symbols......................................................................................................................44
Figure4-2 Shear and lateral pulling when using eye bolts..........................................................................45
Figure4-3 Position of attachment points on gear unit .................................................................................46
Figure4-4 Position of attachment points on gear unit with motor ...............................................................46
Figure4-5 Oil filling point and oil drain ........................................................................................................47
Figure5-1 Gap dimension at the grease labyrinth ......................................................................................53
Figure5-2 Alignment surface.......................................................................................................................54
Figure5-3 Alignment surfaces and alignment threads on gear units of type K..H ......................................54
Figure5-4 Installation procedure for gear unit with three-point housing bearings and solid shaft ..............56
Figure5-5 Gear unit with a hollow shaft and parallel keyway .....................................................................57
Figure5-6 Mounting with a screw spindle ...................................................................................................59