Fluke 5500A - Page 410

5500A
Operator Manual
INDEX-8
Using Commands, 5-25
Using Multiply and Divide, 4-50
Using the 5725A Amplifier, 4-47
Using the Format EEPROM Menu, 4-6
Using the Instrument Setup Menu, 4-5
Using the Operate and Standby Modes, 4-8
Using the Setup Menu, 4-4
Using the Softkeys, 4-4
Utility Functions Menu, 4-6
UUT Connection: Capacitance (Compensation Off),
4-14
UUT Connection: Capacitance (Four-Wire
Compensation), 4-13
UUT Connection: Capacitance (Two-Wire
Compensation), 4-14
UUT Connection: DC Voltage/AC Voltage, 4-15
UUT Connection: Resistance (Compensation Off), 4-
13
UUT Connection: Resistance (Four-Wire
Compensation), 4-12
UUT Connection: Resistance (Two-Wire
Compensation), 4-12
UUT Connection: Temperature (RTD), 4-15
UUT Connection: Temperature (Thermocouple), 4-16
UUT Connections, 4-11
Connecting the Calibrator to a UUT, 4-9
UUT Port
Controlling an Instrument, 5-46
UUT_FLUSH remote command, 6-44
UUT_RECV? remote command, 6-44
UUT_SEND remote command, 6-45
UUT_SET remote command, 6-46
UUT_SET? remote command, 6-46
—V—
V/DIV menu, 8-17, 8-70
VAL? remote command, 6-47
Volt Function, 8-16, 8-69
Specifications, 8-6, 8-60
V/DIV menu, 8-17, 8-70
Voltage
Limit Setting, 4-51
Selecting Line, 2-4
Setting AC Output, 4-19
Setting DC output, 4-18
Voltage Gain Calibration, 8-16, 8-18, 8-69, 8-71
VVAL? remote command, 6-47
—W—
WAI remote command, 6-47
Warming up the Calibrator, 4-4
Watts Performance, Text Screen, 4-59
Wave Generator, 8-28, 8-82
WAVE remote command, 6-48
WAVE? remote command, 6-48
Waveform Types, 4-40
Waveforms
Harmonics, 4-42
Setting Harmonics, 4-42
Sinewave, 4-41
Squarewave, 4-41
Trianglewave, 4-41
Truncated, 4-42
Wavegen Menu, 8-28, 8-82
When to Use EARTH, 4-10
Where To Go From Here, 1-6
—Z—
ZCOMP remote command, 6-48
ZCOMP? remote command, 6-49
Zeroing the Calibrator, 4-7