Chapter 3: Certify Twisted Pair Cabling
The DSX-600 CableAnalyzer Home Screen
45
Shows a summary of the test results in the project:
The number of tests that passed.
The number of tests that failed.
The number of results from tests on twisted pair cable that
have PASS* results. PASS* results have measurements within
the range of accuracy uncertainty for the tester. See “PASS*/
FAIL* Results” on page 58.
The test setup panel shows the settings the tester will use when
you tap TEST or press . To change these settings, tap the
panel.
Icons show the status of the Store Plot Data and AC Wire Map
settings. See Table 2 on page 51.
Next ID: The Next ID panel shows the ID that the tester gives to
the next test results you save.
Tap Next ID to do these tasks:
Enter an ID, select a different ID in the ID set, select a
different set of IDs, or make a new set. The tester adds the
IDs and ID sets you make to the project that shows on the
home screen.
Turn Auto Save on or off.
Operator: The name of the person who does the job. You can
enter a maximum of 20 operator names. For each operator you
can also enter the email address that the operator will use as an
ID to sign in to LinkWare Live.
TOOLS: The TOOLS menu lets you set the reference, see the
status of the tester, and set user preferences such as the
language and the display brightness.
RESULTS: Tap RESULTS to see and manage the results that are
saved in the tester.
To Next Page
Loading...
