DSX-600 CableAnalyzer
Technical Reference Handbook
46
SYNC: To upload results to LinkWare Live, tap SYNC. See Chapter
9.
TEST: Tap TEST to do the test shown in the test setup panel.
The percentage of the project that is completed. The
percentage is the number of IDs used for saved results divided
by the total number of used and available IDs in the project.
% Tested does not show if your project contains only a Next ID
list. See “About Next ID Sets” on page 168 for more information
about the Next ID list.
This icon shows when the tester’s link interface adapter is
connected to the adapter on a DSX-600 remote and the remote
is turned on.
The asset management icon shows when the owner of a
LinkWare Live account has enabled the asset management
service for the tester. See “About the Asset Management
Service” on page 179.
This icon shows when the talk function is on. See “How to
Use the Talk Function” on page 95.
To Next Page
Loading...
