FORST ST6P - Page 8

Redwood Global Ltd - ST6P
Operator and Maintenance Manual
Figure 35 - Feed roller speed adjustment 65
Figure 36 - Idle 66
Figure 37 - Key in the OFF position 66
Figure 38 - Pushing the flywheel away from you 67
Figure 39 - Pulling the flywheel towards you 67
Figure 40 - Spring hanger 68
Figure 41 - Feed roller spring tension 68
Figure 42 - Raising the top feed roller housing 69
Figure 43 - Bonnet 78
Figure 44 - Rotate the discharge chute 79
Figure 45 - Chipping chamber cover bolts 79
Figure 46 - Open chipping chamber cover 80
Figure 47 - Remove bolts 81
Figure 48 - Remove side panel 82
Figure 49 - Pushing the flywheel away from you 83
Figure 50 - Pulling the flywheel towards you 83
Figure 51 - Flywheel locking tool 84
Figure 52 - Installing the flywheel locking tool 84
Figure 53 - Blade removal 85
Figure 54 - Correct position of the back edge of the blade 86
Figure 55 - Blade sharpening wear limit: 80mm to 60mm 87
Figure 56 - Blade gaps 88
Figure 57 - Anvil clamp position 89
Figure 58 - Slide hammer 89
Figure 59 - Anvil removed 90
Figure 60 - Anvil seat 90
Figure 61 - Anvil tight to the bedplate 91
Figure 62 - Anvil in vertical seat 91
Figure 65 - Loosen main tension bolt 93
Figure 66 - Adjust tension 93
Figure 67 - Hydraulic oil filter 94
Figure 68 - Cap on the hydraulic filter housing 95
Figure 69 - Lifting tab 95
Figure 70 - Insert hose 97
Figure 71 - Battery terminals 99
Figure 72 - Jump start 101
12-00-001 v4.0 8