PostBase Mailing System
126
12.4 Correcting the moistening felt position on the rocker
(sealer)
• Slightly tilt the rocker and pull it off in an
obliquely upward direction.
Caution! Make sure to always hold the leg
spring on the pin with one hand while posi-
tioning the moistening felt. This will prevent
the leg spring from jamming or jumping out.
• Push the long moistening felt side fully
underneath the clamping strip such that
– the felt’s recesses are perfectly aligned
with the rocker stop edge and
– both moistening felt outer edges uni-
formly project over the rocker edge by
approximately 1 - 2 mm (0.04 - 0.08").
See illustration.
• Carefully displace the moistening felt in the
clamping strip if necessary.
• Reattach the rocker on the sealer
(see page 115).
To Next Page
Loading...
