FP PostBase - Step 3: Connecting PostBase

PostBase Mailing System
20
Step 3: Connecting PostBase
Warning! Use the power and connection cables provided with the PostBase
or approved by Francotyp-Postalia. Make sure that cables are not damaged.
Connect PostBase only to a grounded single-phase power socket. Make sure
your office power supply conforms to the power requirements indicated on
the serial number plates.
Make sure the socket for connecting PostBase is close by and easily
accessible at all times.
Plug the power plug into the franking
machine’s power connection. Then plug
the power cable into the power socket.
Connect the franking machine
to a local area network (LAN).
Connect the
franking machine to a PC.