Fronius TransSteel 5000 Pulse User Manual

Setup Menu 2nd Level
Limitations The following restrictions occur in relation to the Setup menu 2nd level:
Setup menu 2nd level cannot be selected:
-
during welding
-
if the "Gas test" function is active
-
if the "Wire threading" function is active
-
if the "Wire withdrawal" function is active
-
if the "Gas purging" function is active
If level 2 of the Setup menu is selected, the following functions are not available,
even in robot mode:
-
Welding start-up - the "Power source ready" signal will not be emitted for ro-
bot mode
-
Gas test
-
Wire inching
-
Wire withdrawal
-
Gas purging
Operation
(Setup Menu 2nd
Level)
Accessing the 2nd level of the Setup menu:
MANUAL
STD SYNERGIC
PULSE SYNERGIC
1
Press the "Process" button to select
the "MIG/MAG standard synergic
welding" process
MANUAL
STD SYNERGIC
PULSE SYNERGIC
2T
4T
+
+
2
The control panel is now located in the
Setup menu of the "MIG/MAG stand-
ard synergic welding" process - the last
selected setup parameter is displayed.
3
Select the "2nd" setup parameter us-
ing the left-hand selection dial
MANUAL
STD SYNERGIC
PULSE SYNERGIC
2T
4T
+
+
4
The control panel is now located in the
2nd level of the Setup menu of the
"MIG/MAG standard synergic welding"
process - the last selected setup para-
meter is displayed.
Adjusting parameters
1
Select the desired setup parameter us-
ing the left-hand selection dial
Change the setup parameter value us-
ing the right-hand selection dial
100

Fronius TransSteel 5000 Pulse Specifications

General

Brand	Fronius
Model	TransSteel 5000 Pulse
Category	Welding System
Language	English