MIG/MAG welding
Safety
WARNING!
Danger from incorrect operation and work that is not carried out properly.
This can result in serious personal injury and damage to property.
▶
All the work and functions described in this document must only be carried
out by technically trained and qualified personnel.
▶
Read and understand this document in full.
▶
Read and understand all safety rules and user documentation for this equip-
ment and all system components.
WARNING!
Danger from electrical current.
This can result in serious personal injury and damage to property.
▶
Before starting work, switch off all devices and components involved, and
disconnect them from the grid.
▶
Secure all devices and components involved so they cannot be switched back
on.
▶
After opening the device, use a suitable measuring instrument to check that
electrically charged components (such as capacitors) have been discharged.
Preparation
1
Connect the water hoses of the welding torch to the corresponding connec-
tion sockets on the wirefeeder
(when using the cooling unit and water-cooled welding torch)
2
Insert mains plug
3
Set the power switch to - I -:
-
All displays on the control panel briefly illuminate
-
If present: The cooling unit starts to work
IMPORTANT! Observe the safety rules and operating conditions in the Operating
Instructions for the cooling unit.
Overview MIG/MAG welding is composed of the following sections:
-
MIG/MAG synergic welding
-
MIG/MAG standard manual welding
-
Spot welding and stitch welding
67
EN-US
To Next Page
Loading...
Need help?
General
