MIG/MAG Standard Manual Welding
General The MIG/MAG standard manual welding process is a MIG/MAG welding process
with no synergic function.
Changing one parameter does not result in any automatic adjustments to the
other parameters. All of the variable parameters must therefore be adjusted indi-
vidually, as dictated by the welding process in question.
Available para-
meters
The following parameters are available for MIG/MAG manual welding:
Wire speed
1 m/min (39.37 ipm.) - maximum wire speed, e.g., 25 m/min (984.25 ipm.)
Welding voltageTransSteel 4000 Pulse: 15.5 - 31.5 V
TransSteel 5000 Pulse: 14.5 - 39 V
Arc-force dynamic:
For influencing the short-circuiting dynamic at the instant of droplet transfer
Welding current
Only the actual value is displayed
MIG/MAG
standard manual
welding
1
Press the "Process" button to select the desired welding process:
MIG/MAG standard manual welding
2
Press the "Mode" button to select the desired MIG/MAG mode:
2-step mode
4-step mode
In MIG/MAG standard manual welding, special 4-step mode corresponds to con-
ventional 4-step mode.
72
To Next Page
Loading...
Need help?
General
