Control Panel
General The functions are all arranged in a logical way on the control panel. The individual
parameters required for welding can be
-
Selected by means of buttons
-
Changed using buttons or the selection dial
-
Shown on the digital display during welding.
Due to the synergic function, all other parameters are also adjusted if a single
parameter is changed.
NOTE!
Because of software updates, certain functions may be available for your device
but not described in these Operating Instructions or vice versa.
In addition, individual figures may also differ slightly from the operating ele-
ments of your device. However, the function of these operating elements is
identical.
Safety
WARNING!
Danger from incorrect operation and work that is not carried out properly.
This can result in serious personal injury and damage to property.
▶
All the work and functions described in this document must only be carried
out by technically trained and qualified personnel.
▶
Read and understand this document in full.
▶
Read and understand all safety rules and user documentation for this equip-
ment and all system components.
31
EN-US
To Next Page
Loading...
Need help?
General
