Fronius TransSteel 5000 Pulse - Minimum Equipment Requirements

Minimum equipment for welding operations
General Depending on the welding process, a minimum level of equipment is required to
work with the power source.
The following describes the welding processes and the corresponding minimum
equipment for welding operations.
Gas-cooled
MIG/MAG weld-
ing
-
Power source
-
Grounding cable
-
Gas-cooled MIG/MAG welding torch
-
Gas connection (shielding gas supply)
-
Wirefeeder (VR 5000 Remote)
-
Gas-cooled interconnecting hosepack
-
Wire electrode
Water-cooled
MIG/MAG weld-
ing
-
Power source
-
Cooling unit
-
Grounding cable
-
Water-cooled MIG/MAG welding torch
-
Gas connection (shielding gas supply)
-
Wirefeeder (VR 5000 Remote)
-
Water cooling option (for VR 5000 Remote)
-
Water-cooled interconnecting hosepack
-
Wire electrode
Manual metal
arc welding
-
Power source
-
Grounding cable
-
Electrode holder
-
Rod electrodes
Minimum equip-
ment for arc air
gouging
-
TransSteel 4000 / 5000 Pulse, TransSteel 5000 Syn power source
-
Grounding cable 120 mm²
-
KRIS 13 arc air gouging torch
-
Compressed air supply
43
EN-US