Before installation and initial operation
Safety
WARNING!
Danger from incorrect operation and work that is not carried out properly.
This can result in serious personal injury and damage to property.
▶
All the work and functions described in this document must only be carried
out by technically trained and qualified personnel.
▶
Read and understand this document in full.
▶
Read and understand all safety rules and user documentation for this equip-
ment and all system components.
WARNING!
Danger from electrical current.
This can result in serious personal injury and damage to property.
▶
Before starting work, switch off all devices and components involved, and
disconnect them from the grid.
▶
Secure all devices and components involved so they cannot be switched back
on.
▶
After opening the device, use a suitable measuring instrument to check that
electrically charged components (such as capacitors) have been discharged.
Intended use The power source is intended exclusively for MIG/MAG, MMA, and TIG welding.
Utilization for any other purpose, or in any other manner, shall be deemed to be
not in accordance with the intended purpose.
The manufacturer shall not be held liable for any damages arising from such use.
Intended use also means
-
Following all the instructions in these Operating Instructions
-
Carrying out all the specified inspection and maintenance work
Setup regula-
tions
The device has been tested according to degree of protection IP 23. This means:
-
Protection against penetration by solid foreign bodies with diameters > 12
mm (0.49 in.)
-
Protection against spraywater at any angle up to 60° from the vertical
The device can be set up and operated outdoors in accordance with degree of
protection IP 23.
Direct moisture (e.g., from rain) must be avoided.
WARNING!
Danger from machines toppling over or falling.
This can result in serious personal injury and damage to property.
▶
Set up the device securely on an even, solid surface.
▶
Check all screw connections are tightly fastened after installation.
44
To Next Page
Loading...
Need help?
General
