EasyManuals Logo

Fronius TransSteel 5000 Pulse User Manual

Fronius TransSteel 5000 Pulse
140 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #65 background imageLoading...
Page #65 background image
Spot welding
I
+
I
GPr GPoSPt
t
< SPt
The "Spot welding" mode is suitable for welded joints on overlapped sheets.
Start by pressing and releasing the torch trigger - GPr gas pre-flow time - weld-
ing current phase over the SPt spot welding time duration - GPo gas post-flow
time.
If the torch trigger is pressed again before the end of the spot welding time (<
SPt), the process is canceled immediately.
2-step stitch
welding
GPr SPt SPtSPb
GPo
I I
+
2-step stitch welding
The "2-step stitch welding" mode is suitable for welding short weld seams on thin
sheets, to prevent the weld seams from dropping through the parent material.
65
EN-US

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fronius TransSteel 5000 Pulse and is the answer not in the manual?

Fronius TransSteel 5000 Pulse Specifications

General IconGeneral
BrandFronius
ModelTransSteel 5000 Pulse
CategoryWelding System
LanguageEnglish

Related product manuals