Fronius TransSteel 5000 Pulse User Manual

changes at the same time. The left display then shows the original value
again, e.g., welding current.
Ejt EasyJob Trigger
To activate/deactivate switching between EasyJobs using the torch trigger
Unit: -
Setting range: On/OFF
Factory setting: OFF
Function with MIG/MAG torch trigger
Press torch trigger briefly (< 0.5 s)
No welding taking place:
-
Toggles through all MIG/MAG EasyJobs in sequence.
-
If an EasyJob is not selected, the torch trigger functions normally.
-
If a MIG/MAG EasyJob is not selected, no change is made.
Welding taking place:
-
Toggles through MIG/MAG EasyJobs with the same operating mode
(4-step, special 4-step, 4-step stitch welding) and with the same weld-
ing process.
-
It is not possible to switch during spot welding.
Function with MIG/MAG Up/Down key
If an EasyJob is selected, the EasyJob is changed, otherwise the welding
current is changed.
No welding taking place:
-
Toggles through all MIG/MAG EasyJobs in sequence.
Welding taking place:
-
Toggles through MIG/MAG EasyJobs with the same operating mode
(2-step, 4-step, special 4-step, 4-step stitch welding) and with the
same welding process.
Switching back is possible.
Parameters for
MIG/MAG
standard manual
welding in Setup
menu 2nd level
SEt Country-specific setting (Standard/USA) ... Std/US
Unit: -
Setting range: Std, US (Standard/USA)
Factory setting:
Standard version: Std (measurements: cm/mm)
USA version: US (measures: in.)
C-C Cooler mode
(only when the cooling unit is connected)
Unit: -
Setting range: AUt, On, OFF
Factory setting: AUt
103
EN-US

Fronius TransSteel 5000 Pulse Specifications

General

Brand	Fronius
Model	TransSteel 5000 Pulse
Category	Welding System
Language	English