menu – EnE parameter. The value continuously rises during welding in line
with the permanently increasing energy input. The final value is stored
after the end of welding until welding starts again or the power source is
switched back on - the HOLD indicator lights up.
*) During the MIG/MAG standard synergic welding process and MIG/MAG
pulsed synergic welding process, if one of these parameters is selected,
then the synergic function ensures that all other parameters, including
the welding voltage parameter, are adjusted automatically.
**) In conjunction with the VRD option, the indicator of the currently selec-
ted welding process is also used as status indicator:
-
The indicator lights up continuously: the voltage reduction (VRD) is
active and limits the output voltage to less than 35 V.
-
The indicator flashes as soon as a welding operation occurs, which can
cause the output voltage to be greater than 35 V.
36
To Next Page
Loading...
Need help?
General
