6
Use the "Parameter selection" buttons to select the welding parameters to be
used to specify the welding power:
Sheet thickness
Welding current
Wire speed
Welding voltage
7
Use the appropriate selection dial to set the welding parameter.
The value of the parameter is displayed on the digital display located above.
The sheet thickness, welding current, wire speed, and welding voltage paramet-
ers are directly linked. It is sufficient to change one of the parameters, as the re-
maining parameters are immediately adjusted accordingly
All welding parameter set values remain stored until the next time they are
changed. This applies even if the power source is switched off and on again. To
display the actual welding current during welding, select the welding current
parameter.
8
Open the gas cylinder valve
9
Adjust quantity of shielding gas:
-
Tap the Gas-test button
-
Turn the adjusting screw on the bottom of the gas pressure regulator un-
til the manometer displays the desired quantity of gas
-
Tap the Gas-test button again
CAUTION!
Danger of injury and damage from electric shock and from the wire electrode
emerging from the torch.
When you press the torch trigger:
▶
Keep the welding torch away from your face and body
▶
Wear suitable protective goggles
▶
Do not point the welding torch at people
▶
Make sure that the wire electrode does not touch any conductive or groun-
ded parts (e.g., housing, etc.)
10
Press the torch trigger and start welding
69
EN-US
To Next Page
Loading...
Need help?
General
