Fuji Electric Faldic-a RYS-R Series - Page 237

8-6
MHT260a (Engl.)
(2) Manual operation
By turning on the CONT6 [RUN] of IQ area (as factory set), the motor can be rotated.
For the station No., see 5.8 IQ area (SX bus). If the station number setting is 50, specify "％QX50. 15. 15" to CONT6. If a signal is allocated
to CN1, check the +24 [V] DC power supply to CN1.
(a) Supply power to the amplifier.
(b) Make sure a voltage is outputted from the +24 [V] DC power supply.
(c) Check the connection of forced stop signal (Beware of NC contact input.)
(d) Turn on the run command [RUN] signal.
By the keypad panel of amplifier, make sure the LEDs light according to the run command.
(e) On the keypad panel, the sequence mode recognized by the amplifier can be checked.
(f) The motor starts running by turning on the CONT7 [FWD] signal after turning on CONT12 [X1].
At factory setting, the motor speed is 100 [r/min] (basic para. 1 setting).
(g) Turning off the CONT7 [FWD] stops the motor whether CONT12 [X1] is on or not.
Key operation Indication display (example) Remark
Example of monitor mode display
MODE
MODEMODE
MODE
ESC
ESCESC
ESC
The MODE key selects a mode.
MODE
MODEMODE
MODE
ESC
ESCESC
ESC
Change the mode.
MODE
MODEMODE
MODE
ESC
ESCESC
ESC
Change the mode.
MODE
MODEMODE
MODE
ESC
ESCESC
ESC
Change the mode.
MODE
MODEMODE
MODE
ESC
ESCESC
ESC
Change the mode.
By the ∧ key or ∨ key, select [ ].
SHIFT
SHIFTSHIFT
SHIFT
ENT
ENTENT
ENT
Holding down the ENT key for at least 1 [s] causes a sequence display.
Turning on [RUN] signal displays [ ].