3.4 Programming Mode
3-45
OPERATION USING THE KEYPAD
3.4.8 Setting “Favorites” function code data “Favorites: 0.fnC”
Menu number 0 “Favorites” in Programming mode allows you to display only those function codes in “Favorites”,
and make changes to function code data. There is no limit to the number of function code data items that can be
registered.
Registering and deleting “Favorites”
By pressing the and keys simultaneously while the number of the function code to be registered in
“Favorites” is displayed in menu number 1 “Data Setting”, the function code data is registered in “Favorites”.
The following example describes the procedure for registering and deleting F01 frequency setting 1 in “Favorites”.
By pressing the and keys simultaneously while
f 01
is displayed, the bar at the top indicating that data
has been registered is displayed on the left of the function code. Performing the same operation again deletes the
registered data from “Favorites”, and the top bar disappears.
Fig. 3.4-5 Registering and displaying favorites
By copying data with the keypad, function codes registered in favorites can also be copied.
By writing “13” for H03, all registered function codes can be deleted.
Top bar on left of function code
lights up when registered in
“Favorites”
To Next Page
Loading...
