[ 2 ] Motor protection with thermistor ········································································ 4-38
4.9 Setting function codes when switching from a conventional model ··································· 4-39
4.9.1 Switching from FRENIC-MEGA (G1S) ······························································· 4-39
[ 1 ] Copying function codes using the keypad ··························································· 4-39
[ 2 ] Entering function codes directly from the keypad ·················································· 4-39
[ 3 ] Entering function codes from PC Loader ···························································· 4-40
4.9.2 Switching from FRENIC5000G11S/P11S or FRENIC5000G9S/P9S·························· 4-40
4.10 Operation Check ·································································································· 4-41
4.10.1 Test run procedure ························································································ 4-41
4.10.2 Check points during a test run ·········································································· 4-41
4.10.3 Adjusting the function code for motor control ······················································· 4-42
4.11 Selecting a Frequency Command Source ·································································· 4-44
4.11.1 Setting the frequency from the keypad ······························································· 4-44
4.11.2 Setting the frequency with an external potentiometer (variable resistor) ····················· 4-45
4.11.3 Setting the frequency with multistep frequency selection (1 speed, 2 speed, etc.) ········ 4-46
4.12 Selecting a Run Command Source ··········································································· 4-47
4.12.1 Setting run commands from the keypad ····························································· 4-47
4.12.2 Setting run commands with external signals (terminal [FWD, [REV]) ························· 4-47
To Next Page
Loading...
