Fuji Electric FRENIC MEGA G2 Series - Page 310

5.3 Description of Function Codes 5.3.1 F codes (Fundamental functions)
5-126
 Torque limiter levels specified via communications link (S10, S11)
The torque limiter levels can be changed via the communications link. Communication dedicated codes S10, S11
interlock with the function codes F40, F41.
F42
Drive control selection 1
Related function code: H68 Slip compensation 1
(Operating conditions selection)
F42 specifies the motor drive control. Refer to “Chapter 4 TEST RUN PROCEDURE” for details on the control
method.
F42 data
Control method
Basic control
Speed feedback
Speed control
0
V/f control: without slip
compensation
V/f control
No
Frequency control
1
Dynamic torque vector control
(with slip compensation, auto
torque boost)
Frequency control
with slip
compensation
2
V/f control with slip compensation
3
V/f control with speed sensor
Yes
Frequency control
with automatic speed
regulator (ASR)
4
Dynamic torque vector control with
speed sensor
5
Speed sensorless vector control
Vector control
Speed
estimation
Speed control with
automatic speed
regulator (ASR)
6
Vector control with speed sensor
Yes
15
Vector Control without speed
sensor and magnetic pole position
sensor
Speed
estimation
16
Vector control with sensor
(permanent magnet synchronous
motors)
Yes
 F42 = 0: V/f control without slip compensation
Under this control, the inverter controls a motor with the voltage and frequency according to the V/f pattern specified
by function codes. This control disables all automatically controlled features such as the slip compensation, so no
unpredictable output fluctuation occurs, enabling stable operation with constant output frequency.
If running multiple motors, select this control method.