Fuji Electric FRENIC MEGA G2 Series - Page 610

5.3 Description of Function Codes 5.3.13 K codes (Keypad functions)
5-426
K96
TP-G1 compatibility mode
K96 is used if connecting a touch panel (TP-E1, TP-E1U, TP-G1, TP-G1-J1/C1) for the FRENIC-MEGA (G1) series
(hereafter referred to at G1) to the FRENIC-MEGA (G2) series (hereafter referred to as G2) and copying function
codes.
The following table shows the behavior when using the data copy function with a replacement touch panel.
Behavior when using data copy function with replacement touch panel
Replacement
touch panel
Function code saved
to touch panel
K96
Behavior when copying data
TP-E1
TP-E1U
TP-E2*1
For G1
No setting
necessary
"0" is set for function code K96 when copying data.
For G1X
"1" is set for function code K96 when copying data.
TP-G1
TP-G1-J1/C1
For G1
0
Before copying data, set "0" for function code K96 with TP-
E2, replace the touch panel with the one indicated on the left,
and copy data.
For G1X
1
Before copying data, set "1" for function code K96 with TP-
E2, replace the touch panel with the one indicated on the left,
and copy data.
*1: Supported from ROM 0300 or later.
・Multi-function Keypad TP-A2SW can only be used on the G2. It cannot be used on the G1/GX1.
・K96 appears if connected to G2 keypad TP-E2, but it does not appear if connected to TP-E1, TP-E1U,
TP-G1, or TP-G1-J1/C1.
・If copying data from TP-G1 or TP-G1-J1/C1, it will not be possible if the K96 setting differs from the
model for the data being copied.
・K96 is not initialized with H03.
・Certain function codes are replaced with other function codes, the value of certain function codes is
converted, and certain function codes are not copied.