Fuji Electric FRENIC MEGA G2 Series - Page 760

11.9 High Power Factor Power Supply Regeneration PWM Converters (RHC Series)
11-32
■ Communication specifications
Item
Specification
Communication
specifications
General communication
specifications
Operating information, running status, function code monitor function (polling), and RUN, RST, and X1
control (selecting) is possible.
* Function code writing is not possible.
【DX+】,
【DX-】
RS-485 (built in as
standard)
Communication is possible with the PC or PLC (Fuji standard and RTU protocols are supported).
T-Link (option)
T-Link communication with MICREX-F or an SX T-Link module is possible with the OPC-VG1-TL option.
CC-Link (option)
Connection to CC-Link master devices is possible with the OPC-VG1-CCL option.
SX bus (option)
MICREX-SX and SX bus connection is possible with the OPC-VG1-SX option.
E-SX bus (option)
MICREX-SX and E-SX bus connection is possible with the OPC-VG1-ESX option.
Optical communication (option)
Parallel multiplex system load sharing can be controlled with the OPC-RHCE-TBSI-□ option.
■ Function settings
Function code
Name
F00
Data protection
F01
High-frequency filter selection
F02
Restart mode after momentary power failure (Operation selection)
F03
Current rating switching
F04
LED monitor display selection
F05
LCD monitor display selection
F06
LCD monitor language selection
F07
LCD monitor contrast adjustment
F08
Carrier frequency
F09
Display coefficient for “Input watt-hour data”
E01
X1 function selection
E02 to 13
Y1, Y2, Y3, Y5, Y11 to 18 function selection
E14
I/O function normally open/closed
E15
RHC overload early warning level
E16
Cooling fan ON-OFF control
E17
Current limiting output (hysteresis width)
E18 to 20
A01, A04, A05 function selection
E21 to 23
A01, A04, A05 gain setting
E24 to 26
A01, A04, A05 bias setting
E27
A01 to 5 filter setting
E28, 29
X2 to X3 function selection
H01
Station address
H02
Operation selection when error occurs
H03
Time operating time
H04
Baud rate
H05
Data length selection
H06
Parity selection
H07
Stop bit selection
H08
Communication disconnection time
H09
Response interval time
H10
Protocol selection
H11
TL transmission format
H12
Paralleling system
H13
Number of paralleling system slave stations
H14
Alarm data deletion
H15, 16
Power supply current limiting (for driving 1/2)
H17, 18
Power supply current limiting (for braking 1/2)
H19, 20
Current limiting early warning (level/timer)
H21
Multiplex system station number setting
H22
Cooling fan ON-OFF control continuation timer
H23
Cumulative cooling fan run time default setting
H24 to 26
Clock time setting (set time: month/year, day/hour, minute/second)
H27
Clock time setting (clock time writing)
H28 to 33
Applicable light alarm definition 1 to 6
H34
Simulation failure
H35
Retry (count)
H36
Retry (waiting time)
H37
All save function
H38
Data initialization
H39, 40
For manufacturer: 1 to 2
H41
AVR-P (gain)
H42
AVR-I (integration constant)
H43
ACR-P (gain)