-vii-
4.11.11. How to set the detailed setting ················· 75
5. Mounting of detector ············································ 77
5.1. Detector mounting procedure ··························· 77
5.1.1. Mounting of detector ································· 78
5.1.2. Image figure of mounting dimension ············· 78
5.2. Selection of mounting method ·························· 79
5.3. Mounting method on the pipe ··························· 79
6. CHECK AND MAINTENANCE ······························· 80
6.1. Daily Check ·················································· 80
6.2. Periodic Inspection ········································· 80
6.2.1. Checking zero point ·································· 80
6.2.2. Reapplying grease ··································· 80
6.2.3. How to measure the insulation resistance ······ 81
6.2.3.1. Flow transmitter : FSV···S (IP66) ··········· 81
6.2.3.2. Flow transmitter : FSV···H (IP67) ··········· 82
6.3. How to replace the fuse ·································· 83
6.3.1. Flow transmitter : FSV···S (IP66) ················· 83
6.3.2. Flow transmitter : FSV···H (IP67) ················· 84
6.4. How to replace the LCD ·································· 85
6.4.1. Flow transmitter : FSV···S (IP66) ················· 85
6.4.2. Flow transmitter : FSV···H (IP67) ················· 86
6.5. ERROR AND REMEDY ·································· 87
6.5.1. Display error ··········································· 87
6.5.1.1. Checking the LCD/LED ························ 87
6.5.1.2. Checking the LED lit in red ··················· 88
6.5.1.3. Checking the RAS information ··············· 89
6.5.2. Displaying the data in maintenance mode ····· 90
6.5.3. Keying is abnormal ··································· 91
6.5.4. Error in measured value ···························· 92
6.5.5. Error in analog output ································ 94
6.5.6. Checking received waveforms ···················· 95
6.5.6.1. How to connect the oscilloscope ············ 95
6.5.6.2. Checking sending/receiving ·················· 96
6.5.7. Remedying a hardware fault ······················· 98
7. Appendix ··························································· 99
7.1. Specifications ················································ 99
7.2. OUTLINE DIAGRAM ···································· 101
7.3. ORDERING INFORMATION ·························· 102
7.4. Piping data ················································· 103
To Next Page
Loading...
