Fuji Electric Time Delta-C FSV-2 - How to Set the ID no; How to Confirm the Software Version

-72-
4.11.7. How to set the ID No.
Description

Set the ID No. for parameters (Section 4.4.1).
If ID No. is set, the number must be inputted before canceling the protection.

To validate the protection, set the protection to "ON". (See Section 4.4.1.)
ID No. settable range: 0000 to 9999 (4-digit number)
For actual keying, refer to the typical operation indicated below. Set the protection to OFF beforehand. (See Section 4.4.1.)
If you forget the ID number you set, contact us.
Operation
(example)
Set “1106” as the ID No.
Key operation Description Display
▼
Press the key for 4 times to display “MAINTENANCE MODE”.
MAINTENANCE MODE
ENT
▼
Press the
ENT
key once to display “RAS INFORMATION”.
RAS INFORMATION
0000000000000000
▼
Press the key for 8 times to display “REGISTER ID NO.”.
REGISTER ID NO.
ENT
▼
Press the
ENT
key twice to blink on the 2nd line.
REGISTER ID NO.
0000
▼
Set “1106” by the and the key.
REGISTER ID NO.
1106
ENT
▼
▼
▼
▼
Press the
ENT
key once to register.
REGISTER ID NO.

COMPLETE

↓
――― ID NO. has been registered. ―――
REGISTER ID NO.

ESC
Display the measurement mode by the
ESC
key and the key.
Note) To validate the protection, set the protection to "PROTECT ON".
(See Section 4.4.1.)
0.000 %
0.000 m3/h
4.11.8. How to confirm the software version
Description

Indicates the software version.
For actual keying, refer to the typical operation indicated below.
Operation
(example)
Check the software version.
Key operation Description Display
▼
Press the key for 4 times to display “MAINTENANCE MODE”.
MAINTENANCE MODE
ENT
▼
Press the
ENT
key once to display “RAS INFORMATION”.
RAS INFORMATION
0000000000000000
*
▼
Press the key for 9 times to display “VER. NO.”.
FSV****2
Ver.00A
ESC
After checking, display the measurement mode by the
ESC
key or the
key.
0.000 %
0.000 m3/h
* The indicated version number is display example.