Printer Connection and Software Installation 43
• WPS-PBC (Operator Panel Menu)
You can start WPS-PBC from the operator panel.
NOTE:
• WPS-PBC is available only when the wireless LAN access point (Registrar) or router supports WPS-PBC.
• Before starting WPS-PBC, confirm the position of the WPS button (button name may vary) on the wireless LAN access point
(Registrar) or router. For information about the WPS operation on the wireless LAN access point (Registrar) or router, refer to
the manual supplied with the product.
• The (Wi-Fi) LED lights up or blinks to indicate the printer's wireless connection status. For more information, see "Status
of Wi-Fi LED" on page 22.
If a problem occurs or error messages are displayed on the LCD panel, see "Wireless Problems" on page 229.
1 Press the System button.
2 Select Admin Menu, and then press the button.
3 Select Network, and then press the button.
4 Select WPS Setup, and then press the button.
5 Select PBC, and then press the button.
6 Select Yes, and then press the button.
7 Confirm that the (Wi-Fi) LED starts to blink slowly and Press WPS Button on WPS Router appears,
and then start the WPS-PBC on the wireless LAN access point (Registrar) or router within two minutes.
When WPS is successful, the (Wi-Fi) LED lights up. The wireless connection is established and setup for
wireless LAN is complete.
• WPS-PIN
The PIN code of WPS-PIN can only be configured from the operator panel.
NOTE:
• WPS-PIN is available only when the wireless LAN access point (Registrar) or router supports WPS-PIN.
• For the WPS operation on the wireless LAN access point (Registrar) or router, refer to the manual supplied with the product.
• The (Wi-Fi) LED lights up or blinks to indicate the printer's wireless connection status. For more information, see "Status
of Wi-Fi LED" on page 22.
If a problem occurs or error messages are displayed on the LCD panel, see "Wireless Problems" on page 229.
1 Press the System button.
2 Select Admin Menu, and then press the button.
3 Select Network, and then press the button.
4 Select WPS Setup, and then press the button.
5 Select PIN Code, and then press the button.
6 Write down the displayed 8-digit PIN code, or select Print PIN Code and press the button to print the
PIN code.
7 Select Start Configuration, and then press the button.
8 Confirm that Please Wait... WPS AP Searching appears.
9 Select the SSID of the access point you want to connect to, and then press the button.
10 Confirm that Please Wait... Wireless Setting appears.
11 Enter the PIN code displayed on step 6 into the wireless LAN access point (Registrar) or router.
When WPS is successful, the (Wi-Fi) LED lights up. The wireless connection is established and setup for
wireless LAN is complete.
To Next Page
Loading...
Need help?
General
