Faxing 249
Sending a Fax
You can fax data from your printer.
This section includes:
• "Loading a Source Document on the Automatic Document Feeder (ADF)" on page 249
• "Loading a Source Document on the Document Glass" on page 250
• "Resolution" on page 251
• "Document Type" on page 251
• "Lighten/Darken" on page 252
• "Inserting a Pause" on page 252
• "Sending a Fax from Memory" on page 253
• "Sending a Fax Manually" on page 254
• "Confirming Transmissions" on page 254
• "Automatic Redialing" on page 255
îš„ Loading a Source Document on the Automatic Document
Feeder (ADF)
IMPORTANT:
• Do not load more than 50 sheets on the ADF or allow more than 50 sheets to be fed to the document output
tray. The document output tray should be emptied before it holds more than 50 sheets or your source
documents may be damaged.
NOTE:
• To ensure the best scan quality, especially for gray scale images, use the document glass instead of the ADF.
• You cannot load the following documents on the ADF. Be sure to place them on the document glass.
1 Load a document(s) face up on the ADF with the top edge going in first. Then adjust the
document guides to the correct document size.
2 Adjust the document resolution, referring to "Resolution" on page 251.
Curled documents Pre-punched paper
Lightweight documents Folded, creased or torn documents
Cut and paste documents Carbon paper
To Next Page
Loading...
Need help?
General
