300 Using the Operator Panel Menus and Keypad
• Interval Timer
Purpose:
To specify an interval between transmission attempts within the range of 3 to 255 seconds. The
default is 8 seconds.
• Number of Redial
Purpose:
To specify the number of redial attempts to make when the destination fax number is busy, within the
range of 0 to 9. If you specify 0, the printer will not redial. The default is 3.
• Redial Delay
Purpose:
To specify an interval between redial attempts within the range of 1 to 15 minutes. The default is 1
minute.
• Junk Fax Filter
Purpose:
To reject faxes from the numbers that are not included in the Address Book.
Values:
NOTE:
• Ensure to register the fax numbers you want to accept faxes from in the Address Book before using Junk
Fax Filter.
• Remote Receive
Purpose:
To receive a fax by pressing the remote receive code on the external telephone after picking up the
handset of the telephone.
Values:
• Remote Rcv Tone
Purpose:
To specify the remote receive code in two digits to start the Remote Receive action. As the factory
default menu setting, 00 is specified in advance.
Off* Accepts all faxes.
On Rejects faxes sent from the numbers that are not included in the
Address Book.
* Factory default menu setting
Off* You cannot receive a fax by pressing the remote receive code on the
external telephone.
On You can receive a fax by pressing the remote receive code on the
external telephone.
* Factory default menu setting
To Next Page
Loading...
