68 Printer Connection and Software Installation
Dynamic Methods of Setting the Printer’s IP Address
There are two protocols available for dynamically setting the printer’s IP address:
• DHCP
• DHCP/Auto IP (enabled by default)
You can turn on/off either protocol using the operator panel, or use the CentreWare Internet Services
to turn on/off the DHCP protocol.
NOTE:
• You can print a report that includes the printer’s IP address. On the operator panel, press the (System)
button, select Report / List, press the button, select System Settings, and then press the
button. The IP address is listed on the System Settings page.
Using the Operator Panel
To turn on/off either the DHCP or the AutoIP protocol:
1 On the operator panel, press the (System) button.
2 Select Admin Menu, and then press the button.
3 Select Network, and then press the button.
4 Select TCP/IP, and then press the button.
5 Select IPv4, and then press the button.
6 Select Get IP Address, and then press the button.
7 Select DHCP/AutoIP or DHCP, and then press the button.
Using the CentreWare Internet Services
To turn on/off the DHCP protocol:
1 Launch your web browser.
2 Enter the IP address of the printer in the address bar, and then press the Enter key.
The CentreWare Internet Services appear on your browser.
3 Select Properties.
4 Select TCP/IP from the Protocol Settings folder on the left navigation panel.
5 In the IP Address Mode field, select the DHCP/AutoIP option.
6 Click the Apply button.
To Next Page
Loading...
