Fuji Xerox DocuPrint M255 z

Using the Operator Panel Menus and Keypad 309
• mm / inch
Purpose:
To specify the measurement unit after the numeric value displayed on the operator panel.
Values:
• 2-Sided Report
Purpose:
To specify whether to print a report on either side of paper.
Values:
• Low Toner Alert Msg
Purpose:
To specify whether to show the alert message when the toner is low.
Values:
• Power On Wizard
Purpose:
To perform initial settings for the printer.
See also:
• "Setting Initial Settings on the Operator Panel" on page 45
Values:
Millimeters (mm)*
Inches (")
* Factory default menu setting
2-Sided* Prints a report on either side of paper.
1-Sided Prints a report on the single side of paper.
* Factory default menu setting
Off Does not show the alert message when the toner is low.
On* Shows the alert message when the toner is low.
* Factory default menu setting
Yes Performs the initial settings for the printer.
No* Does not perform the initial settings for the printer.
* Factory default menu setting