Faxing 275
îš„ Available Fax Options
You can use the following options for configuring the fax feature of your printer:
Option Description
Ans Select TEL Mode The printer does not automatically receive faxes. To receive an
incoming fax, you need to pick up the handset of the
connected external telephone, press the 2-digit code, and
press the (Start) button.
FAX Mode This option is selected by default and the printer automatically
receives faxes.
TEL/FAX Mode When the printer receives an incoming fax, the external
telephone rings for the period of time specified for Auto Ans.
TEL/FAX, and then the printer automatically receives the fax.
If an incoming call is not a fax, the printer beeps from the
internal speaker indicating that the call is a telephone call.
Ans/FAX Mode The printer shares the telephone line with an answering
machine and monitors the line for a fax tone. It will pick up an
incoming call if it hears a fax tone. This option is not available
in regions where a serial phone system is employed.
DRPD Mode To use this option, you need to subscribe the Distinctive Ring
Pattern Detection (DRPD) service from your telephone
company that assigns multiple telephone numbers to a single
telephone line and distinguishes each line with a distinctive
ring pattern. Once this service is activated, then you can
configure your printer to monitor the line for the distinctive ring
pattern.
Auto Answer
Fax
Specify a period of time for which the printer waits before entering the FAX Mode
upon reception of an incoming call.
Auto Ans.
TEL/FAX
Specify a period of time for which the printer waits before entering the FAX Mode
when the external telephone receives an incoming call.
Auto Ans.
Ans/FAX
Specify a period of time for which the printer waits before entering the FAX Mode
when the answering machine receives an incoming call.
Line Monitor Select a volume level of the sound that the printer emits from the internal speaker
while establishing a connection for fax transmission.
Ring Tone
Volume
Select a volume level of the ring tone that the printer emits from the internal speaker
to indicate an incoming telephone call while in the TEL/FAX Mode.
Line Type Select the line type.
Dialing Type Select the dialing type.
NOTE:
• DP (10pps) is not displayed when Australia is set for Region.
Interval Timer Specify an interval between transmission attempts.
Number of
Redial
Specify the number of redial attempts to make when the destination fax number is
busy. If you specify 0, the printer will not redial.
Redial Delay Specify an interval between redial attempts.
Junk Fax
Filter
Select whether to reject faxes from the numbers that are not included in the Address
Book.
Remote Receive Select whether to use this option. With this option enabled, you can pick up the
handset and enter the remote receive code to receive a fax.
Remote Rcv
Tone
Specify the remote receive code in two digits for the Remote Receive option.
To Next Page
Loading...
Need help?
General
