Fujitsu ETERNUS CS800 S6 - Page 124

7.2 Accessing Remote Management
l Service - Allowed to view and change information on the ETERNUS CS800 remote
management console.
Password changes are not allowed
l LDAP/AD - Allows users assigned system access through a Lightweight Directory
Access Protocol (LDAP) or Active Directory (AD) server to log into the ETERNUS
CS800 remote management console.
LDAP/AD must be enabled on the LDAP/AD page for this login type to appear (see
"LDAP/AD" on page 319).
Passwords are limited to 32 characters. Alphanumeric characters and special
characters are allowed. Passwords of the local accounts can be changed on the
Access Control page (see "Security" on page 308).
4. Click Login.
5. If you log in as a user assigned to the Admin role (local or LDAP) and there were
previous unsuccessful ETERNUS CS800 logins, a dialog box appears indicating the
previous number of unsuccessful login attempts for both the current account and all
accounts on the ETERNUS CS800(see Figure).
l Click OKto continue.
l Click View Admin Log to access the Administrative Activity Log page (see "Activity
Log" on page 404).
Accessing the Administrative Activity Log page will cause the security
message banner and service ticket banner (if applicable) to not display.
l Click Reset Counts to reset the unsuccessful login count to zero.
Figure 93: Unsuccessful Login Attempts (Admin)
If you log in as a user assigned to the Service (local) or Monitor role (local or LDAP)
and there were previous unsuccessful ETERNUS CS800 logins, a dialog box appears
indicating the previous number of unsuccessful login attempts (see Figure). Click OK
to continue.
Figure 94: Unsuccessful Login Attempts (Service/Monitor)
ETERNUS CS800 124