8.3 VTL Wizard
Figure 105: VTL Wizard: About
Step 2: Add Partition
1. Under Partition Settings, enter information about the partition (see "VTL Wizard: Add
Partition" on page 142).
Name Enter the name of the VTL partition.
Library Model Select the library model emulated by the partition.
The library model determines the inquiry string
returned to the host by the ETERNUS CS800.
The following library models are available:
l Fujitsu CS-TL
l ADIC Scalar 100, ADIC Scalar i2000, or ADIC Scalar
i500
l ADIC Pathlight VX
Number of Storage Slots Accept the default number of storage slots(based on
model), or enter the number of storage slots in the
partition (up to 9,000).
One I/E slot is created for each storage slot up to a
maximum of 240 I/E slots.
Virtual Tape Drive Model Select the tape drive model emulated by the virtual
drives in the partition. All virtual tape drives in a
partition must be the same model.
The following tape drive models are available:
l IBM LTO-1, LTO-2, LTO-3, LTO-4, or LTO-5
l HP LTO-1, LTO-2, LTO-3, LTO-4, or LTO-5
ETERNUS CS800 141
To Next Page
Loading...
