8.3 VTL Wizard
Number of Virtual Tape Drives Accept the default number of tape drives (based on
model), or enter the number of virtual tape drives in
the partition.
If all tape drives are currently assigned to other
partitions, you must remove one or more tape drives
from an existing partition to make them available for
use in a new partition.
Enable deduplication Select the check box to enable data deduplication.
Fujitsu Technology Solutions recommends that you
enable data deduplication to optimize disk usage.
Data deduplication is enabled by default. You
cannot enable or disable data deduplication
after the partition is added.
Enable Auto Export When a tape is moved from a Storage Slot to an I/E
Slot, depending on the Auto Export setting, the
media: will be removed from the virtual I/E slot, if
Auto Export is enabled. (default) will remain in the
virtual I/E slot, if Auto Export is disabled.
2. Click Add.
3. (Optional) To add additional partitions, repeat Steps 1–2.Click Next to continue.
Figure 106: VTL Wizard: Add Partition
Step 3: Add Media
1. In the Partition drop-down box, select the partition where the media will be created
(see "VTL Wizard: Add Media" on page 144).
ETERNUS CS800 142
To Next Page
Loading...
