11.3 Receive NAS
1. To perform a share failback:
On the target system, select a snapshot in the Snapshots List and click Failback.
The Failback Target page displays (see "Failback Target Page" on page 360).
Figure 249: Failback Target Page
2. (Optional) In the Failback Destination System box, type the hostname or IP address of
a new destination system to failback the partition to. (The default destination is the
original source system.)
To use hostname format, you must specify at least one DNS IP address on
the Network page (see "Network" on page 293).
3. (Optional) Leave the Use Encryption check box selected to enable encryption when
sending the snapshot to the destination. Or clear the Use Encryption check box to
disable encryption when sending the snapshot to the destination.
CAUTION!
Select 128-bit encryption if you are sending data to an ETERNUS CS800 running a
system software version prior to ETERNUS CS800 2.1 Software.
AES encryption options are available only if the Data-in-Flight license is
installed.
4. Click Apply.
The snapshot is sent to the source system.
5. On the source system, in the Snapshots List, select the snapshot that was sent during
the failback operation and click Recover.
The Recovered Partition Name page displays.
ETERNUS CS800 360
To Next Page
Loading...
